Description
Specification
|
ITEM |
Technical Parameters |
|
Applicable for |
φ0.25mm&0.90mm Fiber |
|
Optical fiber diameter |
125μm(652A&657B) |
|
Tight buffer diameter (μm) |
250μm |
|
Fiber mode |
Single & multi mode |
|
Operation time |
About 10s(no fiber cut) |
|
Aberage Insert loss |
≤0.10dB(1310nm &1550nm) |
|
Return loss |
≤-40dB |
|
Fastening strength of naked fiber |
>5N |
|
Fastening strength of naked fiber holder |
>10N |
|
Using temperature |
-40~+75°C |
|
Repeatability(10 times) |
△IL≤0.2dB △RL≤5dB |
Instruction:
- Laniate the FTTH flat cable to 50mm , and cut the jacket by scissors.
- Insert the cable to the lead rail tool. as the photo position, and then strip the fiber at the end of tool.
- To check if the fiber is damaged or not ,and then clean it by alcohol.
- Cut the fiber to 13mm.
- Insert the fiber to the Mechanical splicer ,make the cable cut to the stop position of the Mechanical splicer.
- Make the fiber some bending to avoid damage when pull the cable. And then press the clamp at the end to fix the cable.
- Prepare another FTTH flat cable, to insert it the same way as the above steps.
- When the cable cut at the stop position of Mechanical splicer, the fiber is bending , this mean it is correct way to install.
- Press the clamp at both end to fix the cable. Make sure the fiber is bending.
- Push the fixing button to the middle to fix it.
- Press the cover to the chassis and finish the whole installation.
Reviews
There are no reviews yet.